BMR A Arms, Need some advice

[Super Snake]

Have any of you guys installed these on your car?

I'm checking them out...
I have lowered my car and am ready to purchase some STEEDA X5 Ball Joints to go along with the front relocation brackets.

Do I need the X5 BJ's if I install these A Arms?

Thanks
SS

[TOMMY GUN]

I believe Badboy put the BMR stuff on the front of his car.


He hates the ride now and is going to return to some of the stock stuff.


Ask him if this is one of the pieces he put on.


.

[Super Snake]

Originally Posted by TOMMY GUN

I believe Badboy put the BMR stuff on the front of his car.


He hates the ride now and is going to return to some of the stock stuff.


Ask him if this is one of the pieces he put on.


.

Thanks

[TOMMY GUN]

.

[Super Snake]

Originally Posted by TOMMY GUN

.

PM sent

[Super Snake]

BADBOY500 has these A Amrs on his car, he likes them, they are much lighter than stock...

OK now I have a question
My car has been lowerd and I'm going down the path of a relocation kit for the Lower A Arms. Down this path has me buying the Steeda 5X ball joints because the recommend them to further improve roll center geometry. Relocating the rear LCA was a big improvement.

That said, will the 5X BJ's fit in the BMR A Arm?

I just got off the phone with BMR and the said there is no issue with the ball joints in their A arms. and that i should not have issue with my car being lower. Also, I was told that the 5X BJ would not fit in their A Arm.

at the time I called I had not read the discription of what was gaind by the %x BJ's on the steeda website.

anyone run into this and got any suggestions?

thanks
Lonnie

[Super Snake]